Once you have registered your sensor to the ConcreteDNA app you will see temperature data recorded every 20 minutes.
In order to see the strength of the concrete surrounding your sensor monitoring point you will need to set the pour time of when your sensor was covered in concrete.
*If you have installed a sensor in the location where concrete will be poured last this should be recorded in the App to reflect this. Sensors placed at the beginning of the pour will be covered in concrete first and have a faster curing rate to any sensors placed at the end of a pour.
In the app Select pour time:
You will be shown the current time and can scroll back to any time in the past when the sensor was covered in concrete:
*Note: If the sensor is not yet covered in concrete you cannot select the pour time.
You can also input the time the sensor was covered in concrete in the ConcreteDNA web platfrom:
*Note: If the time is input incorrectly contact Converge to get it updated.