
Register your Helix Tail:
1. Create a pour in the ConcreteDNA App.
2. Select sensor type Helix or Signal in the ConcreteDNA App.
3. Register tail in the ConcreteDNA App.
4. Scan tail when prompted by the app.
2. Secure tail to node by aligning the red dots on the connector.
5. Press the button for 5 seconds: the first press will be green (joined network), future presses will be blue (data sent).
6. Refresh App to see data.
FAQ
How do I know my tail is connected correctly?
You will hear an audible click when the red dots are aligned and the sensor plugs into the node.
How do I unplug me tail from the node after the pour is finished?
To unplug the tail pinch the outer edge of the connector and pull.
When should I cut my tail?
Always disconnect the node from the sensor before cutting the tail at desired length.
Can I cause damage to the node when unplugging the tail?
It is important to pinch the outer thread to easily unclip the tail. Be careful not to twist as you pull the tail as this could cause damage to the pins on the node.